NJ Plumbing and Heating, New Safe Solutions for plumbing in NJ and NY from a licenced NJ plumber

Plumber in NJ- Safe Solutions - FloodSafe

The Floodsafe™ Water Detector Shutoff protects the home or business ownerfrom catastrophic damage due to a water heater leak. The Floodsafe™ WaterDetector Shutoff detects the presence of water on the floor beneath the waterheater and automatically shuts off the water supply and the power source tothe water heater.- if you like more info you can call a nj plumber like MRLEAK.COM

Features:
Testable and Resettable: This is NOT a one-time use device. The FloodSafe™ Water Detector Shutoff can be easily reset by the NJ plumbing contractor, home or business owner or plumbing inspector to assure proper operation.

Easily installed on new or existing water heaters.– No special piping is required.– Supplied with a Water Dam for concrete, linoleum, tile or other hard surface fl ooring.– Sized for 3⁄4" or 1" water supply lines.– Secure interlocking connector cables are unique to each connecting device.– Powered by a safe low-voltage Power Supply that plugs into a standard 120 VAC wall outlet and is wired using standard thermostat cable.– No electrician required for gas and oil installations.
Employs state-of-the-art water detection technology (noterminals to corrode or impair operation).

Provides contacts for monitored alarm detection systems.
Power Cutout Modules for the standing pilot gas fi red water heaters retain thermocouple circuit in the event of momentary power outage.

How It Works
The Control Unit, which houses the circuitry, alarm lamp, audible alarm, alarm silence button, andconnector sockets, is installed on the cold water supply to the water heater.
The exclusive Water Detector Pad lays flat on the floor (or in a water heater drip pan).
Upon detection of as little as 1⁄16" of standing water theControl Unit initiates the alarm and shutoff sequence.

Shuts off the water supply to the water heater. Closes the cold water supply to the water heater to minimize water leakage and water damage.

Removes the source of power to the water heater. Should the cause of water detection be from the temperature and pressure safety relief valve discharge, it is important that the supply of energy to the water heater be removed to protect against an extremely hazardous condition or explosion.

Protects your home or business against the danger of explosion.
Energizes an audible alarm and remote alarm contacts. The Floodsafe™ Water Detector Shutoff has an internal alarm to alert the homeowner. It also has contacts that can be connected to a monitored alarm system, to provide 24/7 notification to a home or business security service

for more information call a nj Plumber, our a leak proferional

you can find more info about any heating and plumbing issues, or about nj plumbing, or NJ heatting on our web site :

http://www.mrleak.com/

How To Plunge a Drain

How To Plunge a Drain


When a drain is clogged, whether it's a sink, a toilet, or a tub.
the first thing to do is try breaking up the clog by plunging it.
Or just call a licenced plumber Like Mr leak
( http://www.mrleak.com/ )

A plunger always works better if you put enough water into the fixture to cover the plunger.

If plunging doesn't break up the clog, either blast open the drain with a hose and hydraulic bladder or use a drain auger to snake out the drain. - if you dont have a snake you can call a NY/ or NJ plumber we recumend calling mr leak 201.444.1154


To plunge a toilet, fill the bowl about half full. Push the bell-shape of the plunger down into the drain and, maintaining a tight seal, rapidly pump 15 to 25 times with short strokes. If water doesn't flush down, - call a NJ plumber or NY plumber or any licenced plumber


To plunge a sink or tub, first remove the strainer and pop-up. Stuff a rag or sponge into a plastic bag and use this to plug the overflow hole. If one side of a double kitchen sink is blocked, stuff this plug into the drain hole of the other side. Fill the fixture with enough water to cover the plunger's flat rubber cup (fold the bell shape up inside). Plunge steadily up and down 15 or 20 times
intersperse a few powerful pushes. Keep the plunger tightly sealed against the fixture. A plunger doesn't usually work on floor or shower drains, but it's worth a try; be sure the water level covers the plunger for better plunging.


to get a free estimate by a nj plumber or an nj plumbing co just call 201.444.1154

or if you need emergency plumber in NJ visit : http://www.mrleak.com/